Aluminum Gas Dry Hearth Melting Furnace GM-D-3300
The dry hearth charging chamber has no molten metal in it thus it reduces the dangers of metal splash and prevents temperature drop caused by the addition of cold ingots or scrap to the metal bath. The charging chamber is angled down and as the metal melts it runs into the metal bath.
- Advance PLC control which is easy to learn and operate
- Advanced burner system which reduces generation of oxides
- Charging door on back
- Cleanout door on left side
- Dual temperature control (melting and holding burners)
- Fully automatic operation
- High quality cast refractory lining
- High thermal efficiency
- Large charging rear door
- Large side maintenance door
- Low metal burn rate of less than 1.5%
- Solid frame structure which is easy to clean and maintain
- Temperature alarm
- Temperature control accuracy within 5° C
Item | US Standard | Metric |
Holding Capacity | 3300 lbs | 1500 kg |
Melting Capacity | 1100 lbs/h | 500 kg/h |
Rated Power (melting burner) | 991,416 BTU/h | 250,000 kCal/h |
Rated Power (holding burner) | 793,133 BTU/h | 200,000 kCal/h |
Total Rated Power | 1,784,549 BTU/h | 450,000 kCal/h |
Gas Pressure Requirement | 0.7 PSI | 5 KPa |
Gas Consumption (per ton of alum) | 2500 Cf | 70 Cm |
Furnace Wall Temperature | ≤ 86F | ≤ 30C |
Maximum Temperature | 1560F | 850C |
Dipwell Height | 42” | 1650 mm |
Dipwell Size (W X D) | 23.6” x 21.6” | 600 x 550 mm |
Furnace Size (L x W x H) | 157″ x 77″ x 118″ | 3980 x 1950 x 3000 mm |
Disclaimer: Due to our constant pursuit of technical advancement, all specifications are subject to change without notice.
Loading...